Fluke 434-II Three-Phase Energy Analyzer

Part Number: Fluke 434-IIFeaturesEnergy loss calculator: Classic active and reactive power measurements, unbalance and harmonic power, are quantified to pinpoint true system energy losses inPower inverter efficiency: Simultaneously measure AC output power and DC input power for power electronics systems using optional DC clamp.PowerWave data capture: 435 and 437 Series II analyzers capture fast RMS data, show half-cycle and waveforms to characterize electrical system dynamics (generator start-ups, UPS switching etc.). Waveform capture: 435 and 437 Series II models capture 50/60 cycles (50/60Hz) of each event that is detected in all modes, without set-up.Automatic Transient Mode: 435 and 437 Series II analyzers capture 200 kHz waveform data on all phases simultaneously up to 6 kV.Fully Class-A compliant: 435 and 437 Series II analyzers conduct tests according to the stringent international IEC 61000-4-30 Class-A standard.Mains signaling: 435 and 437 Series II analyzers measure interference from ripple control signals at specific frequencies.400 Hz measurement: 437 Series II analyzer captures power quality measurements for avionic and military power systems. Troubleshoot: Analyze the trends using the cursors and zoom tools.Highest safety rating in the industry: 600 V CAT IV/1000 V CAT III rated for use at the service entrance.Measure all three phases and neutral: With included four flexible current probes with enhanced thin flex designed to fit into the tightest places.Automatic Trending: Every measurement is always automatically recorded, without any set-up.System-Monitor: Ten power quality parameters on one screen according to EN50160 power quality standard.Logger function: Configure for any test condition with memory for up to 600 parameters at user defined intervals.View graphs and generate reports: With included analysis software. Battery life: Up to 8 hours operating time per charge on Li-ion battery pack.